Hello There, Guest! Register



Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thrustmaster racing mount question
#1
Question 
Hello, I've recently gotten into sim racing and got a thrustmaster T300 RS GT edition, TH8A shifter and the classic ebay handbrake for drifting and such.
I just installed the handbrake and it sits a little too far on the table for me to reach, so I'm wondering if the TM racing mount is compatible with the ebay handbrake (the base and table mount is screwed on with 13mm bolts if I'm not mistaken).
If anyone has any experience or a similar setup, please share it here.
I am also very new to these forums, so inform me if I posted this question the wrong topic section.

Mentioned handbrake:
https://www.youtube.com/watch?v=dyxRyXr8QnI
 

   
Reply
#2
(07-04-2022, 03:08 PM)Hi, Dont have an answer but you might have better luck on the SRS Discord channel. https://discord.gg/0qHyHxjO8Dw97nAz  glhf Bachar Hanna Wrote:  Hello, I've recently gotten into sim racing and got a thrustmaster T300 RS GT edition, TH8A shifter and the classic ebay handbrake for drifting and such.
I just installed the handbrake and it sits a little too far on the table for me to reach, so I'm wondering if the TM racing mount is compatible with the ebay handbrake (the base and table mount is screwed on with 13mm bolts if I'm not mistaken).
If anyone has any experience or a similar setup, please share it here.
I am also very new to these forums, so inform me if I posted this question the wrong topic section.

Mentioned handbrake:
https://www.youtube.com/watch?v=dyxRyXr8QnI
 
Reply
#3
Not sure
Since it compatible with TSS Handbrake, try use this picture for measurement reference.
[Image: 47215441632_e2f4dac72d_o.jpg]
Reply
#4
(07-05-2022, 05:50 AM)Handy Hanafiah Wrote:  Not sure
Since it compatible with TSS Handbrake, try use this picture for measurement reference.
[Image: 47215441632_e2f4dac72d_o.jpg]
Hey, thanks for the schematic!
From what I've gathered the TM handbrake is attached to the mount from bellow and there's 4cms in between the centers of the holes where you screw in the mounts/screws (not sure about the correct terminology here, hope you get what I mean)
The ebay handbrake has 4cm from the outside to outside of the screw holes which would cause some overlap.
Do you think it would be possible to use screws with a smaller diameter and lock them really tight? I'm worried this could cause some wiggle or damage the mount.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)